Intelix FLX-44 Uživatelský manuál stáhnout pdf (Strana 12)

FLX-44 Installaon Guide

Connect Audio Outputs

Connect IR Control

If the analog audio outputs are to be used in the installaon, connect

the Le, Right, and ground reference wires to the removable 3-pole

terminal block.

Insert the removable 3-pole terminal block to the appropriate

output zone terminal.

L+

L-

R-

R+

Source Device and Matrix Control via Remote IR

Aach the plasc end of the DIGIB-EMT to the IR receiver of the

source device. Insert the TS 3.5 mm plug of the DIGIB-EMT to the IR

output port (IR OUT) of the matrix for the source device to control.

The FLX-44 has an advanced bidireconal IR control protocol through the HDBaseT output port, which allows for

the control of the sources, displays, and matrix. Intelix recommends using the DIGI-HD60C-R for installaons which

require IR extension.

Only use DIGIB-EMT (IR transmier) and DIGIB-EYE (IR receiver), which are sold separately, with the FLX-44. Third

party 12V DC IR components are not compable with the FLX-44.

An IR signal passed from the display locaon through the HDBaseT connecon can provide control of the source

device. The IR signal from the remote display locaon can also control the switching of the matrix.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Žádné komentáře

Intelix FLX-44 Uživatelský manuál Strana 12